Common problem
AC not cooling
Your AC is running but the room stays warm. Calm, safe checks to try first, what can contribute to weak cooling and what to share when you enquire.
When an air conditioner runs but the room never quite feels cool, it is easy to assume the worst. In many cases the cause is something that can be checked and explained during an assessment. This page sets out what you might notice, what can contribute to the problem and the safe checks you can make before you get in touch. It is general guidance, not a diagnosis of your unit.
What you might notice
Reduced cooling shows up in different ways, and the pattern is often useful information in itself.
- The unit runs for long periods but the room temperature barely changes.
- Air from the outlet feels cool close up but the room stays warm.
- One room cools well while another on the same system does not.
- Cooling is fine early in the morning but struggles in the afternoon.
- The fan runs but the air coming out feels close to room temperature.
- The outdoor unit seems to start and stop more often than usual.
Make a note of which of these fits your situation, along with roughly when it started.
Possible contributing factors
The points below are common contributors to weak cooling. They are listed to help you describe the issue, not to identify the actual fault, which needs a proper look at the equipment.
- Restricted airflow. Dusty filters, blocked return grilles or furniture pushed against an outlet can reduce how much air passes over the coil.
- Soiled coils. Dust and grime on the indoor or outdoor coil can make heat exchange less effective.
- Settings and controls. A thermostat set to fan only, an incorrect mode or a timer schedule can look like a cooling fault.
- Outdoor unit conditions. Restricted space, debris or strong direct heat around the outdoor unit can affect performance.
- Room demand. Large glazed areas, more occupants or a recent change of use can mean the unit is working against a greater load than before.
- A fault in the system. Electrical components, fans or the refrigerant circuit can also be involved. Refrigerant work should only follow a diagnosis of why the level has changed, not be treated as a routine top up.
Safe checks before you enquire
These checks are non-invasive. Do not open panels, remove covers or touch wiring, and do not attempt any work on refrigerant pipes.
- Confirm the thermostat or remote is set to cool, with a sensible set temperature, and check the batteries in the remote.
- Check that timers or scheduled modes are not switching the unit off or into fan mode.
- Look at the indoor outlets and return grilles and move anything that blocks them.
- If your unit has an easily removable filter that the manufacturer intends the user to clean, check whether it looks dusty. If you are unsure, leave it for the assessment.
- From ground level only, look at the outdoor unit and note any obvious debris, blocked space or unusual sounds. Do not climb onto roofs, ledges or ladders to reach it.
- Close windows and doors to the room and give the unit time to run before judging the result.
If anything you notice matches the urgent signs on this page, switch the unit off at the controller and isolate it if it is safe to do so, then seek help promptly.
Information that helps the assessment
Sharing a few details in advance helps Classic Apex understand what to look at and what may be needed on the day.
- The type of system, such as split, ducted or another arrangement, and the number of units.
- Which rooms are affected and whether the problem is constant or comes and goes.
- When the system was last serviced or cleaned, if you know.
- Photographs of the indoor unit, the controller display and any error codes.
- A short video of the outdoor unit running, taken safely from ground level.
- Access details, including building management requirements for apartments.
The AC service selector can help you organise these details into a short service brief.
Which service fits
Most cooling concerns start with AC maintenance and repair, where the unit is inspected and any repair or parts are quoted for approval before work proceeds. Where the assessment points to dust build up on filters, grilles or accessible coils, AC cleaning may be recommended as a separate scope. If the equipment is ageing or no longer suits the space, the conversation may move to AC installation and replacement, with unit selection based on the cooling needs of the room. Share your location when enquiring; visit times are confirmed when you book.
Related problems
AC thermostat concerns
A blank display, wrong readings or an AC that ignores its thermostat? Safe checks to make, possible contributing factors and what to share when enquiring.
Read more ProblemUnusual AC noise
Rattling, buzzing, squealing or clicking from an AC unit? What the sound may relate to, safe checks to make first and the details that help an assessment.
Read more ProblemWater leaking from an AC unit
Water dripping from an indoor AC unit can damage ceilings and finishes. Safe first steps, possible contributing factors and what to share when enquiring.
Read moreEnquire
Describe what you are seeing
Send a short description, when it started and a photograph or video if it is safe to take one. We will advise whether a visit is needed.
Visit times and any assessment charge are confirmed before booking.