Air conditioning
AC maintenance and repair
Inspection, servicing and quoted repairs for air conditioning in homes and commercial premises, for when a unit cools weakly, leaks, makes unusual noise or ignores its thermostat.
Scope and charges are agreed in writing before work starts.
SCOPE
Inspection accessible component checks and quoted repairs.
BOUNDARY
No routine refrigerant top-up without diagnosis.
Overview
What AC maintenance and repair covers
Air conditioning runs for long hours in a hot climate, and small problems tend to show up as a familiar set of symptoms: rooms that never quite reach the set temperature, water dripping from an indoor unit, a rattle or hum that was not there before, or a controller that seems to have a mind of its own. Classic Apex AC maintenance starts by inspecting the accessible parts of the system and working out which of these issues is present and why.
Maintenance and repair are treated as two steps. The inspection covers filters, accessible coils, condensate drainage, airflow and controls. Where a fault is found, the likely cause and the proposed repair, with any parts, are quoted for your approval before work continues. Refrigerant is not topped up as a routine; a low charge points to a leak or other fault that needs diagnosing first.
Suitable for residential and commercial property users.
When it helps
What are you noticing?
Choose the closest description to see what it usually means for the request. This is guidance, not a diagnosis.
Weak cooling
The room takes far longer to cool, or never reaches the set point even with the fan on high. Causes range from clogged filters and dirty coils to airflow restrictions or a refrigerant-side fault.
Request a quotation for thisLeaking unit
Water dripping from the indoor unit or staining the wall beneath it. A blocked condensate drain, a cracked tray or poor drain falls are common reasons, and each is checked during the visit.
Request a quotation for thisUnusual noise
Rattling, buzzing, squealing or clicking from the indoor or outdoor unit. Note when it happens, such as at start-up or continuously, because this helps narrow down the likely component.
Request a quotation for thisThermostat or controller issue
The unit does not respond to the controller, switches off unexpectedly, or the displayed temperature seems wrong. Controller settings, sensor position and wiring to the unit are part of the assessment.
Request a quotation for thisScope
What the assessed scope can include
The final scope depends on the assessment and is written into your quotation.
- 01
Visual and operational inspection
The visit can include running each listed unit, checking airflow at the outlet, listening for abnormal noise and noting visible damage to casings, insulation or pipework.
- 02
Filter care
Servicing can include removing, cleaning or replacing accessible filters, depending on the filter type and its condition, and refitting them so they seat correctly in the unit.
- 03
Accessible coil and fan checks
The inspection can include checking evaporator coil and fan condition where reachable without dismantling, with heavy soiling noted for a separate deep clean.
- 04
Condensate drain checks
Work can include testing the drain tray and line for blockage and correct flow, and clearing accessible blockages where found.
- 05
Controls and thermostat
The assessment can include checking controller settings, batteries where relevant, temperature sensor readings and whether the unit responds properly to each command.
- 06
Fault diagnosis and quoted repair
Where a fault is identified, the work can include diagnosing the likely cause and quoting the proposed repair and any parts before proceeding.
Price factors
What changes the quotation
Classic Apex does not publish fixed prices for this service. Each quotation is based on the actual work, separating labour, materials, access equipment, disposal and applicable taxes.
- System type
- Wall-mounted splits, ducted units, cassettes and fan coils differ in the time and access they need.
- Number of units
- Each unit inspected or serviced adds labour, though several units at one address are planned in a single visit.
- Access to indoor and outdoor units
- Units above high ceilings, in ceiling voids or on roofs may need ladders, access panels or extra time.
- Fault found and parts
- Repairs such as replacing a fan motor, capacitor or drain pump are quoted once the fault is confirmed.
- Condition and last service
- Units that have not been serviced for a long time can need more cleaning effort during maintenance.
Key specification choices
- Maintenance or repair
- A routine maintenance visit for working units differs from a diagnostic visit for a known fault, and the booking should state which is needed.
- Replacement parts
- Where parts are needed, the quotation names whether they are original manufacturer parts or compatible equivalents, subject to availability.
- Diagnosis before refrigerant
- Any refrigerant-related work is preceded by checks for the underlying cause, such as a leak, and the proposed repair is explained first.
Process
How the work is organised
Scheduling depends on the number and type of units, access to outdoor units and whether parts need ordering after diagnosis. Demand for AC work tends to increase in the hotter months, so planning routine maintenance earlier can make it easier to arrange a convenient time. Apartment visits may also depend on building permit and lift booking rules.
Assessment
Your description of the symptoms, unit count and system type is reviewed before the visit. On site, each listed unit is run and inspected, with filters, drains, accessible coils, airflow and controls all checked.
Quotation
Routine servicing proceeds as booked. If a fault is found, you receive an explanation of the likely cause and a quote for the repair and parts before anything further is done.
Work
Approved servicing and repairs are carried out with floors and furniture protected. Water and debris from cleaning are contained, and any additional findings, such as a cracked drain tray, are raised before proceeding.
Completion
Each unit is run and checked after work, the area is tidied and you are told what was done, what was found and any recommendations, such as a deep coil clean.
A preferred visit time is a request. It becomes an appointment only once Classic Apex confirms it.
Preparation
How to prepare
- Note which units are affected and what you have noticed, such as dripping or noise.
- Photograph the indoor unit, outdoor unit and the rating label if you can reach it safely.
- Tell us when the units were last serviced, if known.
- Clear furniture and items from under and around indoor units.
- Confirm access to outdoor units on balconies, roofs or plant areas.
- Switch off and isolate a leaking unit if it is safe to do so, and place a container beneath it.
Free checklist
AC symptom and service selector
Match what you are noticing to the type of AC visit that fits. This is a planning aid to help you describe the issue, not a diagnosis.
Tick what applies and add notes. Nothing is sent anywhere until you choose to request a quotation.
Advice
Useful reading before you enquire
AC servicing and cleaning explained
The difference between AC servicing, routine AC cleaning, deep coil cleaning and duct cleaning, and how to decide which one your units actually need.
Read more GuideGetting ready for an AC service visit
How to prepare for an AC service visit: what to share when booking, how to clear access to units, what to expect on the day and what to check afterwards.
Read more ProblemAC not cooling
Your AC is running but the room stays warm. Calm, safe checks to try first, what can contribute to weak cooling and what to share when you enquire.
Read more ProblemAC thermostat concerns
A blank display, wrong readings or an AC that ignores its thermostat? Safe checks to make, possible contributing factors and what to share when enquiring.
Read moreIs AC maintenance the same as AC cleaning?
They overlap but are not the same. Maintenance focuses on inspection, operation, drainage, controls and fault diagnosis, with filter care included. AC cleaning focuses on removing dirt from accessible filters, grilles, trays and coils. If your unit is dusty but working normally, cleaning may be enough; if it is leaking or not cooling, maintenance with diagnosis is the better starting point.
Why will you not just top up the gas?
An AC system does not consume refrigerant in normal use. If the charge is low, there is usually a leak or another fault, and topping up without finding it can mean paying for the same problem again. Any refrigerant work is quoted after diagnosis, with the proposed repair explained.
What details should I give when booking?
Tell us the system type, such as wall-mounted split or ducted, the number of units, the symptoms for each and when they were last serviced if you know. Photographs of the units and their labels help match the visit to the equipment.
Can you service units on central chilled water?
The in-unit fan coil, filter, drain tray and controls can usually be maintained. The chilled water supply and central plant are the building operator's responsibility. If the unit blows air but never cools, it is worth checking with building management whether chilled water is reaching the apartment.
Related
Often arranged alongside
AC cleaning
Agreed accessible filters grilles trays and coils.
View serviceAC installation and replacement
Assessed equipment installation connections and testing.
View serviceAC duct cleaning
Assessed accessible duct sections vents and grilles.
View servicePart of air conditioning. See the full service directory.
Enquire
Request a AC maintenance and repair quotation
Share the location, the work you have in mind and a few photographs. We will advise on the next step and whether a visit is needed before quoting.
Visit times and any assessment charge are confirmed before booking.