Guide

Clarifying waterproofing in a bathroom quote

What a bathroom quote should say about waterproofing: areas covered, the system, surface preparation, falls, testing and what a refresh leaves out.

By the Classic Apex team · Updated 22 October 2026 · About 5 minutes to read · For homeowners, landlords and property managers comparing bathroom quotations

Waterproofing is the part of a bathroom renovation you will never see once it is finished, and that is exactly why the quotation needs to describe it clearly. Two quotes for what looks like the same bathroom can include very different waterproofing: one renews it across the whole floor and up the shower walls, another treats only the shower tray area, and a third does not mention it at all. Without that detail, the cheaper quote may simply be a smaller scope.

This guide explains the questions to ask so you know what each quotation includes.

Three very different scopes

When you read a bathroom quotation, work out which of these it describes.

  • Full renewal. Existing tiles and screed are removed, the substrate is prepared, and a new waterproofing system is applied to the specified areas before new tiles are laid.
  • Partial or localised waterproofing. Only certain areas, often the shower zone, are stripped and waterproofed. The rest of the floor or walls keeps its existing build-up.
  • No waterproofing work. The scope is a visual refresh: new tiles over existing, regrouting, new sanitaryware or new silicone. This can be the right choice for a sound bathroom, but it does not renew whatever waterproofing lies beneath.

All three are legitimate options in the right situation. The problem arises when a cosmetic refresh is presented, or understood, as if it were a waterproofing renewal.

Which areas are covered

Ask for the waterproofed areas to be described or marked on a sketch. Typical questions include:

  • Is the whole bathroom floor included, or only the shower area?
  • How far up the walls does waterproofing go in the shower, and around a bath?
  • Is there an upstand where the floor meets the walls?
  • How are corners, wall-to-floor joints and changes of plane detailed?
  • How are the drain, pipe penetrations and the concealed shower valve sealed?
  • What happens at the door threshold, where water could pass into the next room?
  • Is the area behind and below a bath included if the bath is being replaced?

Junctions and penetrations are where waterproofing most often fails, so a quote that addresses them specifically is easier to rely on.

The system and the surface beneath it

There are several types of waterproofing system, including liquid-applied membranes, sheet membranes and cementitious coatings. Each has its own preparation, application and curing requirements set by the manufacturer. You do not need to choose the system yourself, but the quotation should name it.

Ask:

  • What product or system will be used, and can you share the data sheet?
  • How will the existing surface be prepared? Loose material, old adhesive and contamination affect how well a membrane bonds.
  • Will reinforcement tape or fabric be used at corners and joints?
  • How many coats or layers are applied, and how is thickness checked?
  • What curing time does the product need before tiling or testing?
  • Is the tile adhesive compatible with the waterproofing system?

Falls and drainage

Waterproofing works with drainage, not instead of it. Water that sits on the floor because the falls are poor puts more demand on grout, sealant and the membrane underneath. Ask whether the screed will be renewed to create falls to the drain, how the drain body connects to the waterproofing, and whether a linear or point drain is planned. If the existing falls are being kept, ask whether they have been checked.

Testing and records

Because the work is concealed, testing and records matter.

Question Why it matters
Will the waterproofing be water tested before tiling? Confirms the membrane holds water before it is covered
How long will the test run, and who checks it? Sets a clear expectation rather than an informal look
Will photographs be taken of each stage? Gives you a record of areas covered and details at junctions
What happens if the test shows a problem? Agrees the correction process before it is needed
Is pipework tested before concealment? Waterproofing cannot compensate for a leaking connection
What written terms apply to the waterproofing? Records any warranty offered and its conditions

If you are in an apartment, building management may want to know about waterproofing works, or may have their own inspection arrangements. Ask them before you agree a programme.

When there is already a leak

If water is reaching a neighbouring room, the ceiling below or a wall behind the bathroom, the source should be diagnosed before a renovation scope is set. The cause might be the waterproofing, but it could equally be a supply pipe, a waste connection, a failed seal around the bath or shower, or something outside the bathroom altogether. Re-tiling without diagnosis risks spending money on finishes while the cause remains. The waterproofing and leak rectification service starts from that diagnosis and defines testing and reinstatement as part of the scope.

Silicone and grout are surface finishes. Renewing them, as covered by silicone sealing and regrouting, can tidy a bathroom and reduce water reaching joints, but it does not replace failed waterproofing beneath the tiles.

Questions to put in writing

  • Is waterproofing included, and is it a full renewal, partial or not included?
  • Which areas are covered, shown on a sketch?
  • Which system will be used, and how is the surface prepared?
  • How are drains, penetrations, corners and the threshold detailed?
  • Will there be a water test before tiling, and will I see the result?
  • How are concealed defects found during strip-out handled and priced?

Next step

Record the waterproofing extent and testing you want in the bathroom planning checklist, so every quotation responds to the same scope. Then share it through the bathroom renovation service page for an assessment of the existing room.

Enquire

Tell us what your property needs

Share the location, the work you have in mind and a few photographs. We will advise on the next step and whether a visit is needed before quoting.

Telephone04 582 4141 Mobile+971 52 568 4874 Emailinfo@cafmglobal.com WhatsAppMessage us

Visit times and any assessment charge are confirmed before booking.

WhatsApp us