Guide
What information helps a plumbing enquiry
What to record and photograph when reporting a plumbing leak, the safe first steps and how to tell a fixture leak from a supply or drainage problem.
By the Classic Apex team · Updated 22 October 2026 · About 5 minutes to read · For homeowners, tenants, landlords and property managers reporting leaks
A plumbing enquiry that says “there is a leak in the bathroom” gives very little to work with. One that says where the water appears, when it appears, how much there is and what it looks like can often narrow down the likely cause before anyone arrives. That saves time on site and helps make sure the right person, tools and parts are planned for. This guide explains what to record and how to share it.
Safe steps before you do anything else
Your first priority is to limit damage and keep everyone safe.
- If the leak is from a single fixture, such as a tap, toilet or basin, close the isolation valve for that fixture if you know where it is and can reach it easily.
- If you cannot find a local valve and the leak is significant, close the main water supply to the property if you know where it is.
- Keep water away from sockets, extension leads and electrical appliances. If water is near electrics, switch off the affected circuit at the distribution board only if you can reach it safely and the area around the board is dry.
- Move valuables and furniture away from the water and put down towels or a container.
- Do not open walls, ceilings or floors to look for the source.
Once the situation is under control, start recording.
What to record
Write down the following. It takes a few minutes and makes a real difference to the first conversation.
| Detail | Why it helps |
|---|---|
| Exact location | Narrows the search, for example “under the kitchen sink, left side” |
| When you first noticed it | Shows whether it is new or has been developing |
| When it happens | Constant, only when a fixture is used, or only at certain times |
| How much water | A slow drip, a steady trickle or active flow |
| Clean or dirty water | Clean water points towards supply; dirty or smelly water towards waste |
| Warm or cold | Can indicate the hot or cold supply |
| Fixtures nearby | Which taps, showers, toilets or appliances are close |
| Recent work | Any repairs, renovation or new appliances recently |
| Building context | Apartment floor, and whether the unit above has a bathroom or kitchen in the same position |
Timing is especially useful. A leak that appears only when the shower runs suggests something different from one that appears regardless of use. If you can, check the water meter with every tap and appliance turned off: a meter that keeps moving when nothing is in use can suggest a supply leak somewhere, which is worth mentioning.
Photographs and video that help
Clear images can show a lot. Take:
- a wide photograph showing the room and where the water is
- a close-up of the wet area, stain or drip
- photographs of the nearest fixtures and the pipework beneath them, if visible without dismantling anything
- a short video of the leak while it is happening, if it is active
- photographs over several days if a stain is spreading, taken from the same position
Include something for scale, such as a coin or a tape measure, if you are photographing a stain.
Fixture, supply or drainage?
Plumbing leaks generally fall into three broad groups. Knowing which one is more likely helps the assessment, although only an inspection can confirm the cause.
- Fixture leaks come from taps, mixers, flexible hoses, toilet cisterns, valves or the seals around them. They are often visible and may only happen when the fixture is used. Our page on leaking taps covers common signs.
- Supply leaks involve pressurised pipework carrying clean water. They may run constantly and can show as damp patches on walls, ceilings or floors near pipe routes.
- Drainage leaks involve waste pipes, traps, floor drains and connections. They usually happen when water is draining and may smell or leave dirty water.
Leaks that come through tiled areas, such as around showers or behind baths, can involve failed sealant, grout or waterproofing as well as pipework. Surface sealing is not a substitute for dealing with failed waterproofing or a concealed pipe leak, so these may need a wider assessment. Waterproofing and leak rectification is assessed separately from fixture repairs.
Leaks in apartments and shared buildings
In apartments, water does not respect unit boundaries. Water appearing on your ceiling may come from the unit above, and a leak in your unit may affect the one below. Shared risers and drainage stacks run through several floors and are normally the building operator’s responsibility.
If you live in an apartment:
- tell building management promptly, especially if water is coming from above or through a shared wall
- note whether the unit above or below is occupied and whether you have been able to contact them
- if you rent, inform your landlord or their agent and confirm who will arrange and pay for the repair
Problems involving shared risers, inaccessible pipelines or concealed leaks may need building management access before the source can be traced. It helps to ask building management whether any other units have reported similar problems, because a pattern across several floors points towards a shared line.
What happens after you enquire
Following an assessment, the likely cause is identified and a repair is proposed for approval. If the source is concealed, the quotation should explain any opening up needed, how the area will be reinstated and whether tiles or paint will be matched. If matching tiles are not available, that should be discussed before work starts, so you can decide whether a wider area should be retiled or whether a close match is acceptable.
Ask, too, what checks will be made after the repair, such as running the fixture and checking for visible leaks, and whether a damp area will need time to dry out before any redecoration.
Next step
Add your notes and photographs to the maintenance planner and include them with your enquiry so the first visit is properly prepared. The plumbing maintenance page explains how leaks, fixtures and pressure concerns are assessed and quoted.